46/361X1/2TC - Guided chamfer cutter 45 degrees

Plastic sleeved for Corian cutters.

• Refs. BNT/2 & BNT/5 are tapered.
• Bearings are shielded to prevent penetration of dust and grease packed for life.
• They should not be cleaned with solvent or lubricated as this will dissolve the grease and cause premature bearing failure.
• Scrape off any resin build-up.
• Always check the tightness of the fixing screw before using cutter.

Spare part packs make ordering spares easier.

• Packs include, hex key (if required), screw, washer and shield (if required).